WARPING SYSTEMS
MW700 / MW1000
Electronically controlled warping machine for elastic and non-elastic yarns.
- Very high motor torque and thread tension
- Extremely high motor running torque even in the case of large beam diameters
- High-precision, synchronisation during constant running, start-up and braking
- Very short stopping times in the case of thread breakages (prevents broken thread ends from running onto the warp beam) as a result of the switching of the drive motors to generative operation and thus the use of all the kinetic energy as braking power
- Siemens S7 control system
- Powered lifting and lower device for the loading of the warp beam at ground level with adjustable end positions in line with warp beam dimensions
- Powered setting of the thrust bearing for the rapid adjustment to differing warp beam widths
- Pneumatic warp beam ejection
- Expanding reed with a laying device with 9 segments in a zigzag pattern in the MW700 and 11 in the case of the MW1000
- Adjustable reed changing device with a stroke of up to 30 mm
- Leasing device
- High-definition metre measurement with shift or day counter
- Programmable warping speed graduation in line with beam start-up
- Safety devices with safety protection switch
- Thread tension control device with negatively driven evener rollers for non-elastic yarns
- Preliminary drafter for elastic yarns
- Width-adjustable contact device for constant pressure during warping; adjustments can be made during warping
- Antistatic device with 2 rods
- Wax or oil device
- Remote control
- Warping machine mounted on rollers
- Load measurement beam for the detection and regulation of thread tension
| Models | MW700 | MW1000 | |||
| Maximum flange diameter [mm] | 600 | 1000 | |||
| Maximum beam length [mm] | 700 | 1000 | |||
| Maximum warping speed [m/min] | |||||
| non-elastic | 800 | 800 | |||
| elastic | 450 | 450 | |||
| |||||
| Positive driven pre-stretcher and roll-off creel for elastic yarns | |||||
| Thread tension compensation rollers for non-elastic yarns | |||||